Hot Runner!

We've received a lot of emails of people wondering when the cases would be available so we thought it was a good time to give a bit of information about the current state of things.

Mid-May, we received what we thought would have been our last sample before we could start production. Unfortunately, some small details still had to be tweaked so it got delayed again.

Upon inspection, we thought we could improve the end-result even more by switching the plastic injection technology used in our mold, by going from cold runners to hot runners.

This ended up adding an extra month to the overall process but the wait will be well worth it. New samples have been molded and are on their way to us as I'm writing this.

Fingers crossed this will be the final batch of samples and we can start producing these amazing looking cases!

Hold on just a little longer!

Hot Runner!